Pool filter ball filter material is a more effective filter material for the purification of high turbidity water in swimming pools. Under the premise of using the pool filter ball filter material correctly, the existence of suspended substances and pollutants in the pool can be effectively reduced. This article will introduce the detailed operation and maintenance procedures of the pool filter ball material to ensure its effective filtration over an extended period.
Preparation before use
Before using the pool filter ball, it is necessary to carefully check the equipment used to confirm that it meets the operating standards, which need to be conducted in accordance with the following standards.
1. Check the equipment: Before starting the operation, check the status of the equipment to ensure that the equipment is not worn or corroded and the filter ball is in good condition.
2. Clean the equipment: Before use, the inside of the equipment must be cleaned. Special cleaning products should be used to clean all the inside of the equipment to avoid foreign matter mixing with the filter ball.
3. Confirm the water source: Before operation, it is necessary to confirm whether the pool water is suitable for the use of pool filter ball filter material. In general, pool filtration balls can only handle water with a water quality of not exceeding 5NTU, a pH of 6-9, and no odor or odor.
Filter operation flow
1. Start the device: Before the operation, start the device and preheat the device. The preheat time varies based on the specifications of different devices.
2. Add the filter ball: Add the pool filter ball to the equipment according to the proportion specified by the equipment. The proportion of the general pool filter ball is 25-50%. After adding the pool filter ball, it needs to be stirred to ensure that it is even.
3. Start filtering: After adding the filter ball, wait 15-20 minutes for natural settling. Then manually open the filter pump to start filtering, and pay attention to monitoring the inlet pressure during the operation. When the inlet pressure exceeds the specified value, the equipment needs to be maintained in time.
4. Maintenance of equipment: In the process of use, it is necessary to regularly maintain the equipment, clean the filter, and confirm that the pool filter ball is in normal condition to avoid blockage or loss.
5. Stop filtration: When you need to stop filtration, you need to close the filter pump first, and then close the water valve. Then open the drain valve at the bottom to drain the residual water.
Maintenance regulations
Pool filter balls require frequent maintenance to ensure their proper operation.
Check regularly
Every three months, it is necessary to check the equipment to ensure that the components are working properly and maintain the equipment’s status.
Maintain the filter ball
Perform regular maintenance on the pool filter ball to remove stains on its surface and prevent clogging..
Replace the filter ball
When the filter ball has been used for an extended period, it needs to be replaced to prevent wear or loss of filter material, which could result in equipment damage.
Conclusion
Through the introduction of this article, we understand the operation steps and maintenance procedures of the pool filter ball. Before using the device, confirm the device status and use the device according to the operating standards. During use, keeping the equipment clean and often maintained can effectively extend the service life of the filter material and ensure the normal operation of the equipment.